Configure camera settings, Configure video format, Video settings attributes – ACTi NVR 3 Corporate User Manual
Page 57: Evidence. for settings in both, Stream functionality, Se re, Nvr 3 corporate system administrator ’s manual
NVR 3 Corporate System Administrator
’s Manual
Configure Camera Settings
After adding a camera to NVR, you may continue to configure its video, motion detection, PTZ
or preset tour settings on
Setup
page
Devices
tab. In this section, we will guide you through
how to configure these settings and their corresponding functions.
Configure Video Format
Go to
Setup
page
Devices
tab, select a camera from
Camera List
, and then go to
Video
tab to configure the video format of the stream output from this camera. If the camera is
currently in Dual Stream mode, you may switch the stream in live view window by click on the
switch below and configure individual settings for
Media 1
and
Media 2
.
Video Settings Attributes
Field Name
Description
TV Standard
Default is
NTSC
Stream Mode
*
1
Select one of the streaming modes this camera supports
Mounting Type
*
2
Select the mounting position
Installation Angle
*
3
Input the angle for a camera mounted on the wall
Video encoder
Select one of the codec this device supports
Resolution
Select one of the resolutions this camera supports
Video Quality
*
4
Select your desired video quality of the image
Frame Rate(fps)
Select the (Frames Per Second) this camera supports.
Maximum Bitrate
This puts a hard cap on the maximum bit rate allowed in any given
second of streaming. Assigning a limited bit rate may cause a few
dropped frames when the stream data overflows the allowed bit rate.
Bitrate
*
5
This is the target bitrate that the camera will attempt to provide when