Welltech WG5290 - Manual (Page 145)

Welltech Computer Co., Ltd.
WellGate 5290 User Guide – V6.1 - 145 -
T1 E&M FGB Wink
T1 E&M FGB Wink (ANI B4 ADDRESS)
T1 E&M FGD Wink
T1 E&M Immediate
T1 E&M Immediate Start
T1 E&M Wink
T1 E&M Wink Start A-Bit Only FXO
T1 E&M Wink Start A-Bit Only FXS
T1 E&M Wink Start
T1 Ground Start FXO
T1 Ground Start FXS
T1 Loop Start FXO
T1 Loop Start FXS
Appendix 11 SS7 Reference Documents
The SS7 Reference Documents form Intel
SPCI2S / SPCI4 User Manual - Issue 5
http://resource.intel.com/telecom/support/ss7/cd/ProductSpecific/SPCI-
CPM8/UserManual-SPCI/u04hsp05.pdf
SS7 Programmer’s Manual for SPCI2S, SPCI4 & CPM8 – Issue 2
http://resource.intel.com/telecom/support/ss7/cd/ProductSpecific/SPCI-
CPM8/ProgrammersManual/u03hsp02.pdf
ISUP Programmer's Manual - Issue 12
http://resource.intel.com/telecom/support/ss7/cd/GenericInfo/ProtocolDocumentation/
U04SSS12-ISUP-PM.pdf
WellGate 5290 FAQ
Q1. Forgotten user password to logon WellGate 5290.
Answer:
a. Logon by a user has Administrator right to reset the user’s password
b. If there is no any users can logon, use the following user/password for
emergency recovery:
User: Serial no (from license card)
Password: first 8 characters of “License Key” (from license card)
c. Use the LCD control panel to change the user id: admin or root’s
password.
Q2. In H.323 Mode: Cannot hear ring back tone for PSTN caller.
Answer:
Normally, the ring back tone is generated by the nearest PABX connected to
WG5290. If a caller from PSTN site cannot hear the ring back tone, please
check: