Welltech SIPPBX 6200A - Manual (Page 85)

3.3.2 DHCP Srv. (IPv4)
To change your DHCP Srv (IPV4) Settings, click Network, and then click the DHCP Srv.
(IPV4) table. The screen appears as shown.
Figure Network: DHCP Srv. (IPV4)
The following table describes the table in this screen
Table Network: DHCP Srv. (IPV4)
Label Description
DHCP Server When select Enable the SIPPBX 6200A provides TCP/IP
configuration for the clients. If disable, DHCP Service ID
disabled and your must have another DHCP Server on your
LAN, or the computers must be manually configured. The
default is Enable.
DHCP Interface 6200A has one WAN and one LAN. User can chose the DHCP
interface (WAN or LAN) to assign IP settings for DHCP client.
Client Range Start IP This field specifies the first of the contiguous addresses in the
IP address Pool.
Client Range End IP This field specifies the End of the contiguous addresses in the IP
address Pool.
Subnet Mask Enter the IP address for Subnet Mask. The default is
255.255.255.0.
Primary DNS Enter the IP address for Primary DNS. The default is
168.95.1.1.
Secondary DNS Enter the IP address for Secondary DNS. The default is null.
SIP Provision Enter the IP address for SIP Provision. The default is
192.168.123.123
Apply Click on the Apply button to save your customized settings and
exit this screen.
- 85 -