Welltech SIPPBX 6200A - Manual (Page 52)

number, then click enter key. The screen will display this page
data.
Next/Prev Click on the Next/Prev to Next/Previous Page. The system will
auto display the Next or Previous Information.
Example 1: Set Trunk for FXO gateway
Click Add/Modify. The screen appears as shown below.
Figure Configuration: Trunk Setting
The following table describes the table in this screen
Table Configuration:
Trunk Setting
- 52 -
Label Description
Trunk Number Assign the number of Trunk. This number is also used as the
register name for Trunk device.
Note: The Trunk Number can also be a “Trunk ID”. In the
Routing Table page, you should define the destination of prefix
route. When you define the prefix route, you should set the
Trunk ID (Trunk Number) in the Trunk page first; then you
could enter the correct Trunk ID in the Destination field.
Password Assign the register password for device to register on SIPPBX
6200A.
Host Setting the Host to Dynamic will require the trunk to register
the SIPPBX 6200A so that the SIPPBX 6200A know how to
reach the trunk. You can also set the Host to an IP address or
FQDN (domain name) if you set the Host to [Pre-define]. There
will be a field called [Address] appeared when you choose Host
to [Pre-define]. This limits only where you place calls to, as the
user is allowed to place calls from anywhere.