Wavetronix SmartSensor Matrix (SS-225) - User Guide User Manual

Page 27

CHAPTER 2 • CABINET SOLUTIONS

Figure 2.7 – Color Label on Plug-in Terminals

Each 6-conductor cable has one DC power wire pair, two RS-485 communication pairs,

and a drain wire (see the above figure). Follow the steps below to land the sensor cables into

the plugs.
1 After routing your SmartSensor 6-conductor cable into the cabinet, carefully strip back

the cable jacket and shielding on the service end of the cable.

2 Open the insulation displacement connectors on the plug by inserting a small screw-

driver into each square slot and rocking it back.

3 Insert the wire leads into the bottom side of the plug-in terminal according to the color

code shown in Table 2.1 and Figure 2.7. Make sure the wires are completely inserted

in the terminal.

4 Close the insulation displacement connector by reinserting the screwdriver into the

square slot and rocking it forward. The plug-in terminals will automatically complete

the electrical connection. There is no need to manually strip the insulation on the end

of each wire.

Do not strip the service end of the cable until after it has been routed through conduit. The

cable should be one continuous run without any splices.