Wavetronix SmartSensor Matrix (SS-225) - User Guide - Manual (Page 100)

CHAPTER 10 • TOOLS 99
Channel Outputs Switch
The Channel Outputs toggle switch and 1–16 checkboxes are used to help assist in testing
of the rack card outputs.
If the Channel Outputs switch is ON, all the selected channel outputs on the Click 112/114
rack card or Click 104 contact closure device will be active. The LEDs that indicate an ac-
tive output channel will light up accordingly. An output will only be active when the cor-
responding box is checked.
Note
It is recommended that you disable pushing by sensors or disconnect the detection
call bus patch cord for each sensor before using this tool. Otherwise, the rack card
may be receiving conflicting calls on its other bus.
The Channel Outputs switch can be very helpful in verifying the I/O channel mapping from
the rack card outputs to the traffic controller inputs. By sequentially checking boxes 1–16,
you should be able to quickly verify the mapping of each channel, even in the absence of
traffic.