Wavetronix SmartSensor 105 (SS-105) - User Guide - Manual (Page 60)

In this chapter
˽ Lane Configuration – Automatic
˽ Lane Configuration – Manual
˽ Verifying Lane Configuration
6
Setting up lanes is simple in SmartSensor Manager because the software will do it for you
with the click of a button. Additionally, if SmartSensor Manager is unable to correctly
configure due to barriers, obstacles or irregular lanes, you can use the Manual Configura-
tion mode to adjust.
Note
Free-flowing traffic in each lane is required for proper configuration. Light or sporadic
traffic may result in slower configurations.
Lane Configuration – Automatic
Follow the steps below to automatically configure lanes in SmartSensor Manager:
1 Select Edit > Lane Configuration.
2 Once the Lane Configuration page opens, click on the Automatic button.
3 If you would like to set constraints on the configuration through the Edit Range
Blinders or Manage Gain buttons, do so now. For more information on these options
see the sections on them in the following pages.
Lane Setup
6