Wavetronix SmartSensor 105 (SS-105) - User Guide - Manual (Page 44)

CHAPTER 4 • COMMUNICATION 43
View Details
Differences between the sensor’s firmware and the firmware bundled with SmartSensor
Manager can be viewed by clicking on View Details. The differences between the two ver-
sions will be highlighted in red. Knowing the details of the detected differences may help
you make a more informed decision about how to proceed (see Figure 4.9).
Figure 4.9 – View Details
˽ Version – Shows the software version.
˽ Programmable Hardware – Shows the FPGA version.
˽ Year – Shows the year of of the version’s release in YY format.
˽ Algorithm/Month – Shows the month of the version’s release in MM format, as well
as the operating mode; this will appear as an S for side fire mode and an F for forward
fire mode.
˽ Day.Application – Shows the day of the version’s release in DD format as well as the
current application; this will appear as an S for sensor or a D for diagnostic.
Connection Properties
Information about the current connection can be accessed on the Current Connection
Properties page, which is found under File > Properties (see Figure 4.10).
Figure 4.10 – Current Connection Properties