Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 90)

4-12 W A N s u i t e 5 3 3 0
Figure 4.9 IP Details Screen
Unit IP Address A unique network address assigned to this unit.
Subnet Mask Defines the network portion of the unit’s IP address.
Gateway IP Address IP address of the default gateway (router) on the LAN side of the unit.
DHCP Client If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Client Identifier Displays a unique identifier for a specific IP address.
Physical Address Displays unique MAC address.
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
NOTICE: If you manually change the IP address, you must “Save and Restart.”
(See "Save and Restart" on page 4-6.)
Supervisory Config Screen
The Supervisory Config screen (Figure 4.10) displays the current speed of the
Supervisory port interface and other parameters as described below.