Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 108)

4-30 W A N s u i t e 5 3 3 0
The unit uses the first three configuration parameters (Protocol Encapsulation,
Proprietary Traffic Type, and Proprietary Offset) to gather statistics. For in-
band management, “RFC 1490” must be the encapsulation method.
Protocol Encapsulation This is the type of encapsulation used by the FRAD/router connected to the
unit.
Values: RFC 1490, Proprietary
Default: RFC 1490
Proprietary Traffic
Type
When Protocol Encapsulation is set for “Proprietary,” the Proprietary Traffic
Type parameter defines which protocol is encapsulated.
Values: IP, IPX, Ethertype, None
Default: None
Proprietary Offset When Protocol Encapsulation is set for “Proprietary,” the Proprietary Offset
parameter defines the number of octets after the frame relay header where the
proprietary traffic type starts.
Values: 0–64
Default: 0
CIR (bps) If a Committed Information Rate is configured here, its value will be used
instead of the default CIR of the frame relay service.
Values: 0–64 k
Default: 0
Be (bps)) If an Excess Burst Rate is configured here, its value will be used instead of
the default excess burst of the frame relay service.
Values: 0–64 k
Default: 0
Bc (bps) If CIR enforcement is configured to “Yes,” the unit will throttle the
Committed Burst down to this value when frames are received with the
BECN bit set.
Values: 0–64 k
Default: 0
Discard Eligible Flag If this parameter is set to “Yes,” and CIR enforcement is also set to “Yes,”
the unit will set the Discard Eligible (DE) bit for frames sent over CIR.
Values: Yes, No
Default: No
In Band Management If the unit is to be used as a gateway to reach a remote WANsuite 5330
through this DLCI, set this parameter to “Yes,” and configure the remote IP
address and Mask in the corresponding endpoint.
Values: Yes, No
Default: No