Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 38)

3-10 W A N s u i t e 5 3 3 0
Current Pin Status
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Serial interface screen.
DTR Alarm Control and Status Table
In addition to the configurable fields, the Serial screen displays a table near
the bottom of the screen that lets you set the Data Terminal Ready (DTR)
Alarm Control parameters and view the current DTR Alarm Status.
Choices for DTR Alarm Control are “Enable” and “Disable”; the default
setting is “Disable.” Setting DTR Alarm Control to “Enable” allows the unit
to go into alarm on a loss of DTR. The DTR Status field indicates the current
state of the DTR alarm.
The Serial screen provides the following user-activated buttons:
To make changes to a Serial port parameter, simply set the parameter to the
desired selection and press the “Submit” button.
10/100 Ethernet (IP Service Details) Screen
The 10/100 Ethernet (IP Service Details) screen (Figure 3.6) lets you
configure the IP parameters listed below.
Figure 3.6 10/100 Ethernet (IP Service Details) Screen
Button Function
Submit Sets any values that have been changed.
Serial Services Displays the Services screen for the Serial interface.
Refresh Refreshes data on the current page.