Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 110)

4-32 W A N s u i t e 5 3 3 0
Receiving FECN/
BECN
When a frame is received with congestion bit set, this parameter is set to
“Yes.” It is set back to “No” when a frame is received without congestion bit
set.
Values: Yes, No
Default: No
CIR Threshold Sets the Tx over CIR alarm threshold. This threshold is the number of bits per
second in excess of CIR during a 15-minute interval. Setting this field to “0”
(zero) disables the alarm.
CIR Alarm Reports if the Tx over CIR threshold has been exceeded.
Bits Over Be Threshold Sets the Tx over Be alarm threshold. This threshold is the number of bits per
second in excess of CIR + Be during a 15-minute interval. Setting this field to
“0” (zero) disables the alarm.
Bits Over Be Alarm Reports if the Tx over Be threshold has been exceeded.
Congestion Threshold Sets the Rx Congestion alarm threshold. This threshold is the number of
frames received with BECN/FECN. Setting this field to “0” (zero) disables
the alarm.
Congestion Alarm Reports if the Rx Congestion threshold has been exceeded.
BECN within CIR
Alarm
Reports if Backward Explicit Congestion Notification (BECN) has been
received within CIR.
UAS Threshold Sets the Unavailable Seconds (UAS) alarm threshold. This threshold is the
number of seconds after which the DLCI is unavailable. Setting this field to
“0” (zero) disables the alarm.
UAS Alarm Reports if the UAS threshold has been exceeded.
DLCI Statistics Screen
The DLCI Details screen provides a “DLCI Statistics” prompt that displays a
table of the statistics for this DLCI as shown in Figure 4.22.