Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 58)

3-30 W A N s u i t e 5 3 3 0
Backup Endpoint If this DLCI has an alternative endpoint to switch to in case this DLCI
becomes inactive, the endpoint index of this alternative endpoint would be
configured here.
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
SLP Reference
Endpoint
This is the reference endpoint index to use for SLA parameters. As most
applications have the same SLAs for all DLCIs, they need to be configured in
only one DLCI entry. All SLA parameters can then be copied from the
endpoint index of this configured DLCI. If no SLP reference endpoint is
configured and the DLCI SLA parameters are not configured, the values in
the Frame Relay Service Details will be used (default CIR, Be, enforcement).
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
Remote IP Address If this WANsuite 5330 unit is to be used to manage a remote WANsuite 5330
unit, the IP address of the remote WANsuite 5330 unit must be configured
here. This DLCI can be used for management only, or for management and
actual data.
If this parameter is set, a PC connected to the LAN interface of this
WANsuite 5330 can reach a remote WANsuite 5330 through this DLCI. The
remote IP address must be part of a different IP network from the local
WANsuite 5330, and the local WANsuite 5330's IP address must be
configured into the PC. This way, local and remote WANsuite 5330s can be
reached regardless of the availability of the routers connected at the back of
the WANsuite 5330s.
Values: IP address
Default: 0.0.0.0
Remote IP Mask If the Remote IP Address is set, the Remote IP Mask must also be set.
Values: IP address
Default: 0.0.0.0
Type If data received from this DLCI has to be switched to its corresponding
destination port, the type must be set to “Switched.” The type should be set to
“Local” for any DLCI used for management purposes only.
Values: Switched, Local
Default: Switched
New DLCI This field is used to create a new DLCI if it is not already configured. To
create a new DLCI, enter a valid DLCI number in the field and click the
“Submit” button. The new DLCI number will be reflected in the DLCI field
of the Endpoint Details screen.