Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 66)

3-38 W A N s u i t e 5 3 3 0
NOTICE: To use this filter, you must specify both the Service and DLCI
parameters in the rule configuration.
IP Address Establishes the IP address by which the rule will filter IP traffic (if enabled).
IP Mask Represents a range of IP addresses defined so that only machines with IP
addresses within the range defined by the mask are allowed to access an
Internet service. To mask a portion of the IP address, replace it with the wild
card character “0” (zero). (For example, 192.44.0.0 represents every computer
on the Internet with an IP address beginning with 192.44.)
Filter By IP Address Enables or disables filtering of the IP traffic by the IP address specified in the
IP Address or IP Mask field.
IP Port Establishes the IP port by which the rule will filter IP traffic (if enabled). You
may enter the port value directly into this field or select a port ID from the
drop-down list to the right of the field (see next paragraph).
Enter or select from... Provides a drop-down list of well-known port IDs for TCP and UDP. To enter
a port ID, select an option from the list and click the “Enter” button. The
selected port ID value will then be reflected in the IP Port field.
Filter By IP Port Enables or disables filtering of the IP traffic by the IP port specified in the IP
Port field.
Tx Alarm Threshold Specifies the threshold in octets for the Transmit Alarm on this rule.
Tx Alarm Shows the current Transmit Alarm status.
IP Port List Provides a drop-down list of well-known port IDs for TCP and UDP. To enter
a port ID, select an option from the list and click the “Enter” button. The
selected port ID value will then be reflected in the IP Port field.
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen displays the number of frames and octets
sent over a DLCI that have been counted in accordance with the Service
Aware “rule” that has been established for a Service. As such, it is frame
relay specific (i.e., DLCIs only occur in frame relay links). In addition, this
screen provides data rate performance information for the period of time you
specify in the Period Index field (see below).