Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 65)

W e b S e r v e r I n t e r f a c e 3-37
The Service Aware screen provides the user-activated buttons described in the
table below.
Rule Configuration Screen (Rule Details)
Use the Rule Config screen (Figure 3.27) to establish Service Aware
parameters. To establish a rule, you must select the desired rule configuration
options and provide the appropriate filter information where required. Then
press the “Submit” button at the bottom of the screen.
Figure 3.27 Rule Config Screen
The paragraphs below describe the rule configuration parameters and their
options:
Service Selects the service to which the rule applies from a pull-down list of
applicable DLCIs.
NOTICE: If you change the Service parameter, you must click on “Submit” to see
the appropriate DLCIs.
DLCI Selects the DLCI to which the rule applies. Select from a pull-down list of
applicable DLCIs.
Filter By DLCI Enables or disables filtering of the IP traffic by the DLCI specified in the
DLCI pull-down list.
Button Function
Rule Details Displays the Rule Configuration screen.
Traffic Meter Stats Displays the Traffic Meter Statistics screen.
Clear Alarms Clears all Service Aware alarms.
Refresh Refreshes data on the current page.