Verilink QUAD T1 (880-503345-001) Product Manual User Manual

Page 25

Quick Set-Up

Verilink QUAD T1 User Manual

2-11

Figure 2-11 Edit Circuit Menu

3. Use the "N" command to change the name of the circuit to

"IMUX_T12".

4. Type "DP" to change the destination port. Use "1,4" again to

continue using the second QUAD T1 module, but select port 2
at the port selection prompt.

5. Type "DM" and use "1-24" to select all 24 timeslots.

6. Since the name and destination port have been changed, the

original circuit has been cloned. Use "S" to setup the circuit.

7. Use "X" to return to the Circuit Manager Menu, then repeat

steps 1 through 6 with these changes.

a. For the next circuit use "IMUX_T13" for the revised name

and select port 3 of the QUAD T1 module in shelf 1, slot 4.

b. For the last circuit use "IMUX_T14" for the revised name

and select port 4 of the QUAD T1 module in shelf 1, slot 4.

Summary

Once all four circuits are built from the second QUAD T1 module to
the IMUX module, the list of circuits shown at the top of the Circuit
Manager Menu should appear as in

Figure 2-12

NOTE: Only the first six circuits in the SCM database are shown

when the Circuit Manager Menu is displayed. To see

additional circuits, use the

N) next page

N) next page command.

-- EDIT CIRCUIT MENU [1,1] SCM Firmware 1.18 --

N) name: IMUX_T11 M) mode: 64k

SP) src port: [1, 5] IMUX data DP) dst port: [1, 4] QUAD net1

SP) src port: [1, 5] IMUX data DP) dst port: [1, 4] QUAD net1
-- port data rate -- DM) -- DS0 map selection --

-- port data rate -- DM) -- DS0 map selection --

-- port data rate -- DM) -- DS0 map selection --
01 02 03 04 05 06 07 08

01 02 03 04 05 06 07 08

01 02 03 04 05 06 07 08
[ 1528 kbps ] 09 10 11 12 13 14 15 16

[ 1528 kbps ] 09 10 11 12 13 14 15 16

[ 1528 kbps ] 09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24

17 18 19 20 21 22 23 24

bus: AUT

S) setup X) exit

A [0.0.0.2] [1,4] QUAD T1 >