Build circuits, Build circuits -6 – Verilink QUAD T1 (880-503345-001) Product Manual User Manual

Page 20

Quick Set-Up

2-6

Verilink QUAD T1 User Manual

Figure 2-5 Configuration Menu for Slot 4

10. Use "I1" to place port 1 into service. No other changes to the

module default settings are required for this example.

11. Use the "C" command and copy the settings for port 1 to all

ports.

12. Use the "T" command to access the timing submenu and verify

that the

R) receive clock from shelf:

R) receive clock from shelf: option is set to yes

yes

yes.

13. This completes the port configuration for this module. Exit to

the Main Menu by typing "X" twice.

Build Circuits

Once the required ports are configured and placed in service, the
circuits are built using the Circuit Build function of the SCM.

Always use the Craft interface of the SCM module, by direct
connection or Telnet, to access the Circuit Build function—instead
of connecting to the Craft interface of the individual modules. This
assures that the SCM remains the central repository of all circuit
routing information.

NOTE: The assumption is made that the ports of the other modules

have been placed in service and configured. Always place

ports in service and configure them before building circuits.

-- QUAD T1 CONFIGURATION MENU --

Port 1 Port 2 Port 3 Port 4

In) in service no no no no

In) in service no no no no
Fn) frame format ESF ESF ESF ESF

Fn) frame format ESF ESF ESF ESF

Fn) frame format ESF ESF ESF ESF
Ln) line coding B8ZS B8ZS B8ZS B8ZS

Ln) line coding B8ZS B8ZS B8ZS B8ZS

Ln) line coding B8ZS B8ZS B8ZS B8ZS
Bn) line build out 0db 0db 0db 0db

Bn) line build out 0db 0db 0db 0db

Bn) line build out 0db 0db 0db 0db
En) equalization n/a n/a n/a n/a

En) equalization n/a n/a n/a n/a

En) equalization n/a n/a n/a n/a
NDn) network density none none none none

NDn) network density none none none none

NDn) network density none none none none
NLn) network initiated loop no no no no

NLn) network initiated loop no no no no

NLn) network initiated loop no no no no
An) alarm declare time(sec) 0 0 0 0

An) alarm declare time(sec) 0 0 0 0

An) alarm declare time(sec) 0 0 0 0
DLn) FDL enable no no no no

DLn) FDL enable no no no no

DLn) FDL enable no no no no
PRM enable yes yes yes yes

PRM enable yes yes yes yes

PRM enable yes yes yes yes
Rn) enable inband/FDL no no no no

Rn) enable inband/FDL no no no no

Rn) enable inband/FDL no no no no
Sn) trunk condition bits(A/B) 0/0 0/0 0/0 0/0

Sn) trunk condition bits(A/B) 0/0 0/0 0/0 0/0

F) FDL configuration

F) FDL configuration
C) copy port T) timing

C) copy port T) timing

C) copy port T) timing
X) exit this menu

X) exit this menu

A [0.0.0.2] [1,4] QUAD T1 >