Verilink PRISM 3060-10 (34-00252.4) Product Manual - Manual (Page 9)

1
G
ENERAL
Introduction The TXPORT PRISM 3010 -400 DSU MP card provides a DDS interface for
customer premises applications. The DSU MP card plugs into a single slot of the
PRISM 3060-10 modular chassis.
The DSU MP card comes with six DSUs (12 ports in TDM mode or 6 ports in
standard modes).
All configuration for the card can be done in minutes. Configuration can be done
through the front panel LCD, embedded VT100 user interface, through telnet, or
the TXPORT 8100A Site Controller. The DSUs can be independently programmed
for any of the available time slots.
The DSU MP card provides quick trouble isolation. The interface can be looped
from any of the management interfaces. Bit error rate testing (BERT) can be
generated and detected in either direction: toward the network in the assigned
channel(s) as well as to the DTE equipment. Alarms are generated for both the
network and DTE sides.
The chapters in this manual are arranged as follows.
1 General - Introduces the product and describes product specifications.
2 Installation - Describes unit mounting, configuration, and interface connections.
3 Operation - Describes the front panel controls and indicators, unit testing, and
control port features.
4 Terminal Operation - Describes the terminal interface setup and the menu-based
screens which appear during a local or remote session.
A Management Information Base (MIB) Reference - Decsribes in detail how the
embedded SNMP agent conforms to RFC 1213 and RFC 1406.
B Customer Service - Provides TXPORT Customer Service telephone and ordering
numbers
Features
✦ Dual 120-pin connectors
✦ Internal BERT
✦ Multiple loops