Verilink PRISM 3060-10 (34-00252.4) Product Manual - Manual (Page 42)

34 O PERATION
DIRECT. Sends reports to a printer or terminal connected directly to the
supervisory port.
DIAL. Sends reports through an attached AT command set compatible modem
connected to the SUPV serial port, which must dial out to a remote modem.
DIAL NMS. Calls the EM8000 to dump alarms directly.
Edit Primary and Secondary Dial String
These fields are 18-character ASCII strings for the call-on-alarm telephone
numbers used in the
DIAL and DIAL NMS modes. The unit makes three attempts
to connect using the primary number. If all three attempts fail, the unit makes three
attempts to connect using the secondary number (if it is not blank). If the
secondary number fails, the unit waits five minutes and then attempts to
communicate using the primary number again. When a connection is detected, the
unit outputs the notification message (as described in Edit Element ID below) and
disconnects.
Edit
Element ID
Allows the user to enter a 29 -character ASCII string which identifies the unit to
the device receiving the alarm notification messages.
Remote
Link
The unit utilizes a remote link to communicate with remote units. The facility data
link (FDL) may be used in cases where the T1 path is not routed through
equipment that blocks the FDL. If the network framing mode is set to D4 or the
FDL is not available, a spare channel may be assigned. Possible channel selections
are those that have not been assigned for use with a high-speed port or passed
through to the T1 DTE. The choices are FDL, None, and Channels 1 to 24.
Log Off If the unit is not programmed with a password, the user may leave the menu
system by pressing Exit from the Main Menu. If a password has been
programmed, the unit prevents an inadvertent log off by requiring the user to press
Select in the Log Off menu. Once logged into the front panel, the interface
remains active until the user logs out.
Main Menu
> Log Off
Figure 3-19 Log Off Screen