Triplett RWC1000K/RWC1000NP - Manual (Page 44)

42
PRINTING
STEP-BY STEP INSTRUCTIONS FOR USING EXCEL:
After you have installed the driver and connected the RWC1000 to
the PC, launch Excel. Select FILE, OPEN and select RWC1000.xls
(either from your RWC software CD or hard drive).
PRINTING FROM A PC
Microsoft Excel
The workbook you are opening contains macros.
Some macros may contain viruses taht could be harmful to your computer.
If you are sure this workbook is from a trusted source, click
"Enable Macros". If you are not sure and want to prevent
any macros from running click "Disable "Macros".
Disable Macros
Enable Macros
Do Not Open
Excel asks you if you wish
to "Enable macros". Select
"Enable macros". Say "No" if
asked if you want to open as
a "Read Only" fi le.
Microsoft Excel
No network testers found
OK
Excel alerts you that it has not found
the tester. Click OK to continue and use
the Import Report routine (below) to
locate the tester. .
Import Report
Serial Port
Detect Testers Import Readings Edit Report
Com1
The Import Report screen with
3 buttons appears. "Detect
Testers" is automatic.
The RWC spreadsheet's fi rst step is to automatically
assign a COM (serial) port to your USB connection and detect the
RWC tester. The COM port number selected is displayed in the
window (1 through 9 is acceptable). The "Import Reading" button will
only be enabled if a RWC tester is detected. If Detect Testers does
not work, it will respond with the error message "No Network Testers
found." Verify the tester's power is ON and try again. If the problem
still persists, see "Error messages" on the following page.
Detect Testers