beautypg.com

5 – using the mixer panel, Mixer” page – Teac US-366 User Manual

Page 19

background image

TASCAM US-366

19

5 – Using the Mixer Panel

CAUTION

With the US-366 model, if the sampling frequency is set to

176.4 kHz or 192 kHz, the signal selected using the “DIGITAL

OUTPUTS” item will be output regardless of the “LINE

OUTPUTS 3-4” setting.

Foot Switch Mode

When using a US-366 with a DAW application, you can

connect a TASCAM RC-3F foot switch remote control (sold

separately) to control the DAW.
You can select from two types of functions for the pedals

(switches).

• PLAY (REW, PLAY/STOP, FWD) (default setting)

These assigned functions are particularly useful for

playback operations. The PLAY/STOP function assigned

to the center pedal allows you to press it briefly to PLAY

and press and hold it to STOP.

• RECORD (PLAY, REC, STOP)

The assigned functions are useful particularly for

recording operations.

FOOT SW

L (brief)

C (brief)

R (brief)

L (long)

C (long)

R (long)

PLAY

REW

PLAY

FWD

-----

STOP

-----

RECORD

PLAY

REC

STOP

-----

-----

-----

Foot Switch Protocol

You should set the protocol to match the DAW application

you are using. If the foot switch remote control does not

function, change the setting.

Mackie:

Mackie control protocol

HUI:

HUI protocol

For information about these protocols and how to use them

with a DAW application, refer to that application's operation

manual.

“MIXER” page

Click the MIXER tab to open the page shown above. On this

page, you can adjust the built-in mixer settings.

1

DYNAMICS EFFECTS type selection

Select the type of dynamics effect to use.
You can select and use one type of effect at a time. (Simulta-

neous selection of two or more effects is not possible.)

ON:

Effect name blue

OFF (default): Effect name gray

Click the name of the effect that you want to use to turn it

on. When on, the effect name appears blue.
Click the name of the effect that is on (name blue) to turn it

off. When off, the effect name appears gray.
To use a different effect, click the name of that effect to turn

it on. The previously used effect is automatically turned off.
This setting is retained even when the unit is turned off and

on again.

NOTE

Depending on the sampling frequency setting, it might not

be possible to turn an effect on.

2

Dynamics effect assignment

Select the channel that you want to use the dynamics effect

on.
You can select one mono or one stereo channel. (Simulta-

neous selection of multiple channels is not possible.)

ON:

Channel name blue

OFF (default): Channel name gray

Click the name of a channel to assign the dynamics effect to

it. When assigned, the channel name becomes blue.
At the same time, the line between the dynamics effects area

and the channel name turns blue.
To stop applying the dynamics effect to the assigned

channel, click that channel's button. The line between the

dynamics effect area and the channel turns gray.
To reassign the dynamics effect to a different channel,

click the button of that channel. The dynamics effect will

automatically be removed from the previous channel (line

turns gray) and assigned to the new channel (line turns

blue).
This setting is retained even when the unit is turned off and

on again.