Teac US-366 - Manual (Page 13)

TASCAM US-366
13
3 − Installation
4. Click the “Restart” button to quit the installer and restart the
computer.
8 Working with Gatekeeper
Depending on the Gatekeeper setting, a warning message
might appear during installation.
The solution depends on the warning message shown.
See the following explanations for details.
• When the Gatekeeper setting is “Allow applications
downloaded from: the Mac App Store"
"'TASCAM_US-322_US-366_X.XX' can't be opened because it
was not downloaded from the Mac App Store.” might appear
as a security warning message.
In this case, click the OK button to close the message. Then,
control-click (or right-click) the file and click “Open”.
When the “'TASCAM_US-322_US-366_X.XX' is not from the
Mac App Store. Are you sure you want to open it?” security
warning message appears, click the “Open” button.
This warning message might also appear when the
Gatekeeper setting is something other than “Allow applica-
tions downloaded from: the Mac App Store".
The file still might not open and “'TASCAM_US-322_
US-366_X.XX' can't be opened because it was not
downloaded from the Mac App Store.” might appear again.
In this case, copy the file from the folder where it is to the
desktop or another folder, and then open it. Alternatively,
change the Gatekeeper settings to “Allow applications
downloaded from: the Mac App Store and identified devel-
opers” and try opening it again.
• When the Gatekeeper setting is not “Allow applications
downloaded from: the Mac App Store"
"'TASCAM_US-322_US-366_X.XX' is an application
downloaded from the Internet. Are you sure you want to
open it?” might appear as a security warning message. In
this case, click the “Open” button.
• Changing the Gatekeeper setting
The Gatekeeper setting can be changed using the “Allow
applications downloaded from:” item on the “General” page
of the “Security & Privacy” pane of the System Preferences.
To change this, you must click the lock icon ( ) at the
bottom left and enter a password to unlock the settings.
This setting will lock again when you click the “Show All”
button at the top left of the window to close the open pane
or when you quit the System Preferences by, for example,
clicking the round button at the top left corner of the
window ( ) or typing command-Q.
CAUTION
Changing the Gatekeeper settings could result in security
risks.
If you changed the Gatekeeper setting to decrease security
(use one of the lower settings), set it back to the original
setting after updating the driver and/or firmware.
Uninstalling the driver
8 Windows
There are two ways to uninstall the driver.
Uninstalling from the “setup.cmd” file used during
installation
1. Follow the procedures in steps 2 to 4 of “Installing the driver
for Windows” on page 11.
2. In step 5, click the “Remove the driver” button.
3. The following screen appears when uninstallation has
completed.
Click the “Reboot now” button. The uninstaller will quit and
the computer will restart.