Teac DP-008EX - Manual (Page 52)

52
TASCAM DP-008EX
7 – Recorder Functions
Confirming the result
Raise the bounce destination TRACK LEVEL knob
(turn other TRACK LEVEL knobs all the way down)
and the MASTER LEVEL knob, and start playback
from the beginning of the song. If you are not
satisfied with the result because, for example, the
balance between instruments is poor, or the pan
settings are wrong, use the undo function. (See
“Undoing operations (undo)” on page 49.)
If you are satisfied with the result, when the
recorder is stopped press the BOUNCE/MIXDOWN/
MASTERING button to open the
RECORDER MODE
screen and select
MULTI TRACK
.
After bouncing tracks, you can record again on
(overwrite) tracks other than the bounce tracks.
TIP
If it is possible that you might need the original
tracks at some later time, back-up the track data to
a computer or copy the song before bouncing(See
“Copying songs” on page 40.) (See “Connecting
with a computer” on page 75.)
Locate and search functions
Direct locate function
The current recorder position is shown at the top of
the Home Screen in “hours: minutes: seconds: frames”
(30 frames per second).
You can move the current recorder position to a
specific time by inputting it here.
1. On the Home Screen, use the HOME button
to move the cursor (underline) between time
counter divisions.
You can edit the value at the cursor positions.
The seconds are selected in the following figure.
2. Use the DATA wheel to change the value above
the cursor(underlined).
When adjusting, the value will carry over
automatically when it reaches the highest or
lowest value in a field. For example, when using
the DATA wheel to increase the value in the
seconds field, the number will change from 59 to
0 and the minutes value will increase by one.
NOTE
When the DATA wheel is being turned, the
following pop-up message appears.
3. Press the HOME button to move to a different
time division and use the DATA wheel to change
the value.
4. After setting the desired time value, press the
Play (7) button to start playback from that
position.
Returning to the song beginning (RTZ
function) or the point where recording
was last started (LRP function)
Use simple button operations to return to the
beginning of a song (00h00m00s00f) or to locate to
the position where recording last started.
RTZ is short for “Return To Zero,” and LRP is short for
“Last Recording Position.”
Return To Zero (song beginning at 00h00m00s00f)
Press them [RTZ] button while pressing and
holding the Stop (8) button.
Last Recording Position (the position recording
last started)
Press the , [LRP] button while pressing and
holding the Stop (8) button.
This function is useful when you want to record the
same passage again.
Search backward/forward
When stopped, press the m [RTZ] button/, [LRP]
button to search backward/forward.
Each time you press one of these keys, the speed
increases from 10x to 50x, 100x and 1000x.
During playback, press and hold the m [RTZ]
button/, [LRP] button to search backward/
forward. During playback, the search backward/
forward speed is fixed at 10x.