Teac DP-008EX - Manual (Page 18)

18
TASCAM DP-008EX
2–Quick Start Guides
5. Return to the beginning of the song
(00h00m00s00f) and press the Play (7) button
to begin playback of the recording on TRACK 1.
Play the lead guitar part along with the already
recorded rhythm guitar.
You can hear both TRACK 1 playing back and
the sound of the input guitar through the
headphones.
6. As necessary, use the TRACK 1 and 2 LEVEL and
PAN knobs, the MASTER LEVEL knob and the
VOLUME dial on the back of the unit to adjust
the monitoring levels and balance.
7. When you are finished checking, press the Stop
(8) button to stop playback.
8. Return to the beginning of the song
(00h00m00s00f) and press the Play (7) button
while pressing and holding the Record (0)
button to begin recording. Play the lead guitar
part.
The Record (0) indicator lights and the TRACK 2
REC indicator stops blinking and stays lit.
9. When you are finished playing, press the Stop (8)
button to stop recording.
10. Press the TRACK 2 REC button to turn its REC
indicator off.
NOTE
If the indicator continues to light even when the
TRIM knob is turned down, the guitar signal itself
is too loud. In this case, if the input source is set to
Ext. Input/High
, change it to
Ext. Input/
Mid
or
Ext.Input, LINE/Low
. If the input
source is set to
Ext. Input/Mid
, change it to
Ext. Input, LINE/Low
. If the OL indicator
lights even when set to
Ext. Input, LINE/
Low
, lower the volume output from the guitar.
Record vocals on TRACK 3
1. Press the ASSIGN button to open the
INPUT
ASSIGN
screen.
2. Press the TRACK 3 REC button to set the
TRACK
3 SOURCE
to
B
.
3. Press the HOME button to return to the Home
Screen.