Teac DP-008EX - Manual (Page 21)

TASCAM DP-008EX
21
2–Quick Start Guides
5. Press the F4 [OUT] button to set the OUT point at
the point where you want to end the mix down
for the stereo master track.
A
SET OUT!
pop-up message appears.
TIP
You can also use the F3 [IN] and F4 [OUT] buttons
to set the IN and OUT points when playback is
stopped.
6. When you are done setting the IN and OUT
points, press the Stop (8) button to stop
playback of the song.
7. When the recorder is stopped, press the
BOUNCE/MIXDOWN/MASTERING button to
open the
RECORDER MODE
screen.
8. Use the data wheel to select (highlight)
MIXDOWN
.
9. Press the F4 [EXEC] button to put the unit into
MIXDOWN
mode.
After a
Mixdown!
pop-up message appears, the
Home Screen reopens.
NOTE
When the recorder is in MIXDOWN mode,
“MIXDOWN” appears highlighted at the top left of
the Home Screen
10. Press the Record (0) button while pressing and
holding the Play (7) button to start recording
the stereo master track from the IN point.
Recording automatically ends at the OUT point.
NOTE
•
The IN and OUT points must be at least four
seconds apart. If they are less than four seconds
apart, a
Trk Too Short
(track is too short)
pop-up message appears and you will not be able
to change the recorder to
MIXDOWN
mode.
•
You can use the LEVEL knobs to adjust the track
and overall levels as you record.