Teac MX-2424 v1.04 - Manual (Page 51)

Using Auto Punch with Loop Mode
If the MX-2424 is set to perform an Auto Record/Rehearse and Loop Mode is engaged then the Auto Punch will be
executed at the In and Out points during the Loop operation. When used in this way the MX-2424 will function as
described below for the three possible settings of Menu 210.
Play Repeatedly This setting will cause the MX-2424 to play from the In point (minus Pre-Roll), punch in
at the In point, punch out at the Out point and continue playing for the amount of time set
as Post Roll then repeat until STOP [34] is pressed or Loop Mode is cancelled. (This is
the default setting.)
If recording in Non-Destructive mode recording passes may be undone with the UNDO
[12] button. NOTE: No Undo is available when recording in TapeMode.
Play Once & Cue This setting will cause the MX-2424 to play from the In point (minus Pre-Roll), punch in
at the In point, punch out at the Out point and continue playing for the amount of time set
as Post Roll then locate back to the In point (minus Pre-Roll) and stop, disengaging Loop
Mode. (This is similar in operation to a TASCAM DTRS machine.)
51