Teac MX-2424 v1.04 - Manual (Page 23)

Edit Keys:
The EDIT [1] key is pressed to allow selection of the track(s) to be edited. When a track is selected the green SEL
LED is lit for that track. Edits are performed to audio on selected tracks using the In and Out points. (Please refer
to Editing Functions for more detail)
[6] CUT
Pressing CUT [6] will perform a Cut operation to the selected track(s) between the In and Out points.
Pressing [19] then CUT [6] will perform a Local Cut operation to the selected track(s)
between the In and Out points.
[7] COPY
Pressing COPY [7] will perform a Copy operation to the selected tracks(s) between the In and Out points.
Pressing [19] then COPY [7] will perform a Split operation to the selected track(s) at the
current position of the Play Head.
[8] CLEAR
Pressing CLEAR [8] will perform a Clear operation to the selected track(s) between the In and Out points.
Pressing [19] then CLEAR [8] will perform a Discard operation to the selected track(s)
according to the In and Out points.
[9] PASTE
Pressing PASTE [9] will perform a Paste operation on the selected track(s) at the In point.
Pressing [19] then PASTE [9] will perform a Sync Paste operation on the selected
track(s) relative to the position of the Play Head.
[10] INST
Pressing INST [10] will perform an Insert operation on the selected track(s) at the In point.
Pressing [19] then INST [10] will perform a Sync Insert operation on the selected
track(s) relative to the position of the Play Head.
[11] OPEN
Pressing OPEN [11] will perform an Open operation on the selected track(s) according to the In and Out points.
Pressing [19] then OPEN [11] will perform an In To Now operation on the selected tracks
at the location of the Play Head according to the In and Out points.
[12] UNDO
This key reverses the last edit operation. This key will also undo the previous recording pass if the MX-2424 is in
non-destructive mode. There are 100 level of undo available. In and Out points will be updated according to the
operation that has been undone. (NOTE: Undo is not available in TL-Tape Mode.)
[13] REDO
REDO reverses the last UNDO edit operation. This key will also restore recordings that were undone in Non-
Destructive Record. In and Out points will be updated according to the operation that has been redone.
23