Teac MX-2424 v1.04 - Manual (Page 50)

Using Loop Mode
There are three Loop Modes determined by Menu 210 as described below:
Play Repeatedly This setting will cause the MX-2424 to play from the In point (with Pre-Roll) through the
Out point (with Post-Roll) repeatedly until the STOP key {34} is pressed. (This is the
default setting.)
Play Once & Cue This setting will cause the MX-2424 to play from the In point (with Pre-Roll) through the
Out point (with Post-Roll), then locate back to the In point (with Pre-Roll) and stop,
disengaging the LOOP key.
Play Once & Stop This setting will cause the MX-2424 to play from the In point (with Pre-Roll) through the
Out point (with Post-Roll) and stop, disengaging the LOOP key.
Once the desired Loop Mode is set in Menu 210, Loop Mode may be used as described below:
From the MX-2424:
Press LOOP [26] to immediately initiate the Loop operation as set in Menu 210 relative to the In and Out points.
To cancel Loop mode press STOP [34].
It is also possible to cancel Loop mode on the fly by pressing PLAY. In this case LOOP will be disengaged and the
transport will continue playing. If the MX-2424 is recording then pressing PLAY will also punch out.
From the RC-2424:
Press LOOP [74] to immediately initiate the Loop operation as set in Menu 210 relative to the In and Out points on
the MX-2424 currently selected by the MACHINE SELECT [72] keys.
To cancel Loop mode press STOP [34].
It is also possible to cancel Loop mode on the fly by pressing PLAY. In this case LOOP will be disengaged and the
transport will continue playing. If the MX-2424 is recording then pressing PLAY will also punch out.
(NOTE: The MX-2424 will not loop over “midnight” {time code location 00:00:00:00} including Pre/Post Roll. If
it is necessary to use 00:00:00:00 as the In point of a Loop operation then the pre-roll will have to be set to zero.)
50