Teac MMR-16 v4.0 - Manual (Page 95)

MMP-16 TASCAM MMP-16 Owner’s Manual • Chapter 5 • MMP-16 Setup Menus 97
200 Transport
210 Loop Mode
Sets the behavior of the MM series machine when the Loop function is active. The choices for the setting
are:
§ Play Repeatedly Loops until the transport is stopped (default).
§ Play Once and Cue Plays once from pre-roll before In to post-roll after
Out then cues to pre-roll before In point and stops.
§ Play Once and Stop Plays once from pre-roll before In to post-roll after
Out then stops at end of post-roll.
211 Loop Record
Sets the behavior of the MM series machine during Loop Record operation. Choices are:
§ Repeat Record
Loop Record until the transport is stopped (default).
§ Record Once Only Records once from In to Out then cues to pre-roll
before In point and stops.
§ Repeat w/Unload Record from In to Out then unloads track and records
new track. Loop record continues, creating a new track
with every loop until stopped.
212 Pre-roll
Sets the amount of time before the In point (called the pre-roll amount) used for loop play and record
functions. The default value is 00:00:05:00.
213 Post-roll
Sets the amount of time after the Out point (called the post-roll amount) used for loop play and record
functions. The default value is 00:00:02:00.
220 Next / Previous Mode
Sets which type of edit is used to determine the location of the next and previous edit points when
working with WaveFrame projects only. These edit points are used in the Go to Next or Go to Previous
edit commands in the transport control section of the ViewNet interface. The default value is Event.
§ Event
Moves the playhead to the next or previous WaveFrame Event.
See the WaveFrame documentation for information on events.
§ Cue Moves the playhead to the next or previous WaveFrame Cue. See
the WaveFrame documentation for information on cues.
221 Edit Sync Mode
This setting affects where a clip will be pasted during an edit operation.
§ In point Sets the paste to place the beginning of the region stored in the
clipboard at the In point. (default value)
§ Playhead Sets the paste to place the contents of the clipboard to the selected
edit tracks in the same position relative to the Playhead as those
contents occupied when the material was placed on the clipboard.