Teac HS-P82 - Manual (Page 43)

TASCAM HS-P82
43
Use the number buttons to input the start time for the time
code generator.
If you begin input without selecting a digit, input will occur
in order from the smallest place.
Touch a digit to select it for input. When selected, the digit’s
background color becomes yellow. Use the number buttons
for the DATA dial to enter two digits at a time.
Touch the
ENTER
button to confirm.
Touch the
CLEAR
button to reset the values to 0.
TIP
You can use a PS/2 keyboard to set these values. Press the ESC
key to reset all the digits to 0.
Mixer settings (MIXER SETUP)
Make mixer settings on this screen.
The
MIXER SETUP
screen has 3 pages:
INPUT
,
SIGNAL
PROCESSING
and
SETUP
. Touch the tabs at the bottom of the
screen to open the corresponding page.
INPUT page
Make input settings on this page.
INPUT SOURCE
Set the input source for each channel (A1–A8: analog
inputs, D1–D8: digital inputs). (Default settings:
A1
–
A8
)
PHANTOM POWER +48V
Turn the phantom power for each input ON or OFF.
(Default settings: all
OFF
)
Fs CONVERT
Turn the sampling rate converter ON or OFF for each
pair of inputs. (Default settings: all
OFF
)
NOTE
You cannot turn Fs CONVERT ON for the digital input selected
for the master clock.
Press a channel button on the top line to open the
corresponding
CHx SETUP
screen.
SIGNAL PROCESSING page
Turn phase inversion, low-cut filters and limiters ON and
OFF on this page.
PHASE (ø buttons)
Touch these buttons to turn phase inversion ON or OFF
(The phase is fixed at 180º). (Default settings: all
OFF
)
Low Cut Filter
Touch these to turn the low-cut filter ON or OFF. Touch
the
LowCut Filter
button to open the
LOW CUT FILTER
setting screen. (Default settings: all
OFF
)
LIMITER
Turn the limiter ON and OFF. (Default settings: all
OFF
)
Press a channel button on the top line to open the
corresponding
CHx SETUP
screen.
LOW CUT FILTER (button)
Touch the
LowCut Filter...
” button on the
SIGNAL PRO-
CESSING
page of the
MIXER SETUP
screen to open the
LOW
CUT FILTER
screen.
ON/OFF
Turn the low-cut filter ON or OFF. (Default settings: all
OFF
)
FREQ
Touch the knob for the cutoff frequency that you want to
adjust. Use the
DATA dial to adjust it. The setting values
are
40Hz
,
80Hz
(defaule) and
120Hz
.
6 – Internal Settings and Operations