Teac DR-2D - Manual (Page 35)

TASCAM DR-2d
35
Set where to save the file
Set the folder where recorded files are saved. If no setting is
made, new recording files are placed in the
MUSIC folder. (See
“Folder operations” on page 54.)
Setting the input functions
1 Press the MENU key to open the Menu Screen.
2 Use the wheel to select INPUT SETTING , and press the
ENTER/MARK key.
INPUT SETTING screen appears.
This screen has the following setting items.
Use the  and ¯ keys and the wheel to set each item.
INPUT:
Set the input source to microphone ( MIC ) or line ( LINE ). The
default setting is MIC .
When MIC is selected, sets the input source as the built-in
microphone when no microphone cable is connected to the
MIC IN jack (stereo mini-jack). When a microphone cable is
connected to the
MIC IN jack, the input microphone signal
becomes the input source.
When
LINE is selected, sets the source as the line level signal
input to the left side panel LINE IN jack (stereo mini-jack).
GAIN:
Set the mic input sensitivity as HIGH , MID , or LOW .
The factory default setting is MID . Change it to HIGH if the
input level is too low and to
LOW
if the input level is too high.
TYPE:
Select STEREO or MONO according to the type of connected
microphone. The factory setting is STEREO .
If you select
MONO
, the left and right channels are combined into
the same signal.
POWER:
When connecting a microphone that requires plug-in power set
this to
ON
. The factory default is
OFF
.
LOW CUT:
The factory default setting of the low cut filter is OFF , but you
can also select 40Hz , 80Hz or 120Hz as the cut-off frequency
for a low cut filter.
4–Recording