Super Systems 9120 with TS - Manual (Page 9)

SSi 9120 Touchscreen Interface
4586 – 9120 With Touch Screen Interface Page 9 of 80
o Out of band condition detected – Indicates that the current probe has just
gone out of band
o Changing to probe n in sss seconds – Indicates that the specified probe will be
selected in the time frame provided. The message will count down while the timer
is active.
•
Both inputs less than 950 mV – Neither probe can be selected when both inputs are
less than 950 mV.
•
Input n over 1300 mV – The indicated input is over range.
•
Both inputs over 1300 mV – Both inputs are over range.
•
Probe Deviation – The selected alarm is active. See the alarms section for instructions
on setting up the alarms.
The list of error conditions is:
•
Alarm 1, Alarm 2, or Alarm 3 – The selected alarm is active. See the alarms section for
instructions on setting up the alarms.
Note: The alarm text will always be displayed if an
alarm is active regardless of the 9120’s setup .
The Menu button will display the menu options that will allow the user to configure the 9120
unit. The Chart button will display the chart screen. See the
Menus Screens sections for
instructions on the menus and the Chart Screen.