Super Systems 9120 with TS - Manual (Page 52)

SSi 9120 Touchscreen Interface
4586 – 9120 With Touch Screen Interface Page 52 of 80
2400 19200 76800
4800 28800 115200
9600 38400
Host 232 Mode
This will allow the user to set the RS232B mode.
Note – This must be set to Modbus for the
Touchscreen . The options are: Modbus, Cal Term, Televac, Modbus Master, or Sorensen.
Host 485 (3,4) Baud
This will allow the user to set the Host 485 baud rate.
This must be set to 19200 for the
Touchscreen .
The options are:
1200
14400 57600
2400 19200 76800
4800 28800 115200
9600 38400
Host 485 (3,4) Mode
This will allow the user to set the Host 485 mode. The options are: MMI, Modbus, or ADAM.
Host 485 Address
This will allow the user to set the Host 485 address. The range is 1 to 249.
Slave 1 (5,6) Baud
This will allow the user to set the Slave 1 baud rate.
The options are:
1200
14400 57600
2400 19200 76800
4800 28800 115200
9600 38400
Slave 1 (5,6) Mode
This will allow the user to set the Slave 1 mode. The options are: MMI, Modbus, ADAM,
Yokogawa, or Modbus host.
Slave 2 Baud
This will allow the user to set the Slave 2 baud rate.
The options are:
1200
14400 57600
2400 19200 76800
4800 28800 115200
9600 38400
Slave 2 Mode
This will allow the user to set the Slave 2 mode. The options are: MMI, Modbus, ADAM, SSi
Analog Input Board, or Yokogawa.
IP Address