Super Systems 9120 with TS - Manual (Page 24)

SSi 9120 Touchscreen Interface
4586 – 9120 With Touch Screen Interface Page 24 of 80
Input Type
The thermocouple type for most applications can be modified depending on your specific needs.
Please note that in some applications, some of the inputs DO NOT allow the user to modify the
Input type.
Note - Before changing the input type, make sure to set the appropriate jumpers, if
necessary . The jumper will need to be manually changed on the input board before changing the
input type to a 10:1 setting (non-thermocouple types) . To change the Input type, first select
which input you want to change by selecting it in the pull-down menu at the top of the screen.
Once selected, click
OK and the displayed Input type under Value will be the current type.
The following is a list of the options:
T/C B
T/C S 12.5 volts ***
T/C C T/C T 781.25mv
T/C E 2.56 volts 195.3125 mV
T/C J 1.28 volts
T/C K 78.125 mV
T/C N 19.53125 mV
T/C NNM 4-20 mA ***
T/C R 25 volts ***
***
When the specified input type is selected, a jumper located inside the case will
need to be placed on that specific input for reading this selection. If jumper is not
placed on input, then damage could occur to the board
. ***
Filter time
The filter time is a factory applied averaging tool used to help maintain steady control in high EMI
environments. The filter time should not be adjusted with consulting SSI. The range is 0 to
32767.
Initial Scale
This is the initial scale value. Clicking on this value will display an input box from which the user
can select a new value. This could also be referred to as the starting value. For example, the
initial value is the value when 0 volts is on the selected input; or on a 4-20 mA input, it would be
the value at the selected input of 4 mA. The range is –32768 to 32767.
Full scale
This is the full scale value. Clicking on this value will display an input box from which the user
can select a new value. The range is –32768 to 32767.
Decimal Point Location
This is the decimal point location value. Clicking on this value will display an input box from
which the user can select a new value. This will affect the PV value and the location of the
decimal when it is displayed. The range is 0 to 4.
Open TC behavior
This is the open TC value. The options are: up scale, down scale, one trip point, or two trip
points.
Input Offset