SP Controls PixiePro - Manual (Page 28)

Group 4 - Interface Settings
Configure the “look and feel” of the PixiePro.
Setting 1 - Button Click On/Off (toggle)
Deselect Button Click to mute the PixiePro audio feedback that accompanies button presses during
normal operation.
Default: Enabled (PixiePro emits a clicking sound when buttons are pressed)
Setting 2 - Button Click on Every Macro Send (toggle)
When enabled, the PixiePro will emit a single click sound for every code sent from in a macro
sequence. When disabled, the PixiePro will beep only a single time when a macro sequence is sent.
Default: Disabled
Setting 3 - LED Brightness Level (0-0 through 0-7)
Set the LED brightness to a fixed level. If the PixiePro is configured with Ambient Light Adjust, this
setting defines the maximum LED brightness.
Range: 0-0 = dim, 0-7 = bright
Default: 0-7 (maximum)
Setting 4 - Enable Ambient Light Adjust (toggle)
When enabled, the PixiePro will automatically adjust display brightness to match room lighting con-
ditions. When disabled, the PixiePro dispaly runs at a constant brightness level.
Default: Disabled
Setting 5 - Volume Animation (toggle)
When enabled, Volume Up/Volume Down commands are indicated by a volume LED level strobing
animation.
Default: Enabled
Setting 6 - Press-and-Hold Off (toggle)
Select to require users to press and hold the Power Off button for two seconds to send the off com-
mand.
Default: Disabled
Example - Setting Button Click Sound: Press Aux 4 to select the Interface Settings group. Press
Source 1 to select the Button Click Sound settings. Use Volume Up/Volume Down to toggle
between on and off. On setting is indicated by all volume LEDs illuminating, off setting is indicated
by all volume LEDs dark. Once the appropriate selection has been made, press any power button to
accept selection.
25