SP Controls PixiePro - Manual (Page 21)

Cloning Procedure Using CAT5
PixiePro units may be cloned using CAT5, CAT5e, or CAT6 cable, eliminating the need to hold the
units upright for the duration of cloning. Cloning over CAT5 takes approximately two minutes.
1. Connect the two units with a straight CAT5, CAT5E, or CAT6 cable. Plug the cable into the female
RJ45 receptacles on both units to make connection. Cloning will not work with a null modem cable.
2. Set the donor PixiePro to Configuration Mode. Press and hold any button while gently inserting a
paper clip into the small hole labeled "insert paper clip to enter Learning Mode". The PixiePro will
enter Configuration Mode, indicated by a blinking red Learning Mode Indicator LED on the front of
the PixiePro and a continuous clicking sound. The PixiePro will remain in Configuration Mode while
the paper clip remains in the Learning Mode aperture.
3. Set the Clone Unit to cloning mode. Gently insert a paper clip into the IR Learning aperture.
Press and hold any button on the Clone Unit and, while holding the button, remove the paper clip.
Caution: Be gentle with the paper clip to ensure that you do not damage switch mechanism.
The PixiePro will rapidly chirp for as long as it remains in cloning mode.
4. The Clone Unit will wait for a wireless cloning signal for about 10 seconds. During this time the
Donor Unit will remain inactive. After 10 seconds, the Clone Unit will begin wired cloning, and both
units will begin clicking for about 2 minutes.
5. When the Clone Unit has completed copying codes from the donor, it will beep loudly 3 times and
reset. You will see all of the button LEDs flicker in quick succession. After the PixiePro has reset it
will be fully operational, and it will have learned all of the codes programmed into the Donor Unit.
18