Mount brackets and basin to wall – Sloan EW-62000 Installaton User Manual
Page 4

4
2
Mount Brackets and Basin to Wall
1/4”-20 x 1/2” Truss Head Screw
(Actual Size)
2-1/2”
(64 mm)
1-1/4”
(32 mm)
32” (813 mm)
APPROXIMATE LOCATION
32-1/4” (819 mm)
APPROXIMATE LOCATION
1/8” (3 mm)
APPROXIMATE LOCATION
8-3/4” (222 mm)
APPROXIMATE LOCATION
7-1/2”
(191 mm)
“F”
SEE TABLE ON
PAGE 2
2-1/2”
(64 mm)
1-1/4”
(32 mm)
3-3/8” (86 mm)
APPROXIMATE LOCATION
8-3/4” (222 mm)
APPROXIMATE LOCATION
7-1/2”
(191 mm)
DISTANCE BETWEEN
BRACKETS - STEP 2B
32” (813 mm)
APPROXIMATE LOCATION
FINISHED FLOOR
HEAD SECURING
LOCATIONS (2)
HEAD SECURING
LOCATIONS (3)
FINISHED FLOOR
“F”
SEE TABLE ON
PAGE 2
DISTANCE BETWEEN
BRACKETS - STEP 2B
DISTANCE BETWEEN
BRACKETS - STEP 2B
DISTANCE BETWEEN
BRACKETS - STEP 2B
D
Mount Basin and Brackets to wall using fasteners with washers that hold over 1000 lbf (pounds-force) withdrawal load each.
Note: If desired, detach Brackets from Basin and mount Brackets to wall first. Then mount Basin to Brackets using 1/4”-20 x 1/2” Truss Head Screws.
Grid Strainer may be installed prior to attaching Basin to Brackets. Refer to Step 3.
E
Level Brackets in all
directions before tightening
fasteners securely. If desired,
apply caulk between Basin
and Wall.
Note: If installation is on soft wall
place 1/16” thick stainless or
galvanized steel sheets between the
Wall and the Brackets. These sheets
must be larger in area than the
mounting surfaces of the Brackets,
and must have thru-holes that align
with the Bracket’s mounting holes.
A
Attach Brackets to Basin using 1/4”-20 x 1/2”
Truss Head Screws. Double Station uses six
(6) Fasteners. Triple Station uses eight (8)
Fasteners.
B
Measure distance between brackets. Make
sure the carrier (when needed) can
accommodate the proper location for the
brackets.
C
Determine the appropriate location for the holes to secure the brackets to the wall. Use the following dimensions as a reference.
DOUBLE STATION
DOUBLE STATION
TRIPLE STATION
TRIPLE STATION
1/4”-20 x 1/2”
TRUSS HEAD SCREWS (6)
1/4”-20 x 1/2”
TRUSS HEAD SCREWS (8)
DISTANCE BETWEEN
BRACKETS
DISTANCE BETWEEN
BRACKETS