Skutch Electronics CBC 9000 - Manual (Page 21)

Al Sandige Page 21 12/05/01
When the tape is playing and you wish to stop it
press the # key until the tape stops.
• Reset the Tape Counter
The message tape counter can be reset to zero
in the PLAYBACK mode at any tape location. To
reset the count to zero press 5 5 5 in the TAPE
STOP position.
• Que & Review
Que and Review is an option that can be turned
on or off in the SETUP MODE under
PARAMETERS A. The factory setting for this
feature is OFF. When turned on, audio from the tape
can be heard over the speaker while the unit is
rewinding and fast forwarding. This feature can be
helpful at locating information on the RECEIVER
tape.
• Exit
If you have entered the playback mode directly
from a dial session, you must press * while the tape
is stopped, to return to the dial session; otherwise,
stop the tape, then momentarily press the RESET
button.
0 Memory Edit
To enter this mode press RESET 0 #. This
MODE allows the user to inspect and delete phone
numbers stored in memory. The ENTRY
POSITION of the number in memory is used to
select the number to be viewed.
::::::EDIT::::::
Enter POS____<#>
At this point enter the position of the number
that you wish to view. The DIAL STATUS of the
number will be displayed directly following the
number.
:::::ENTRY::0001
7866186CONTACT
The following is a list of the various DIAL
STATUS:
CONTACT – Answer, Hang Up, Recorded
Message or Other
BUSY – Busy
NO ANSWER – No Answer
Blank – New Number, never dialed
The DIAL STATUS of the number may be
changed at this point. If you wish to change the
number's STATUS to CONTACT, press 1. If you
wish to change the number's STATUS to Never been
dialed, press 3. If you wish not to alter the STATUS
press the # key.
•
Quick Scan
Pressing the * key allows you to automatically
advance to the next number in memory. This feature
allows you to step through the numbers one at a
time.
• Print Memory (4000)
This feature allows the user to print a list of the
phone numbers stored in memory to a printer. The
DIAL STATUS of the number will be printed
following each number (see STORE). To activate
this feature, enter 4000 for the position number.
--PRINT MEMORY--
Please Wait!
• Duplicate Delete (5000)
This feature allows the user to automatically
delete duplicate numbers that are stored in memory.
It should be noted that this function changes all of
the DIAL STATUS of all of the numbers to NEVER
BEEN DIALED. To activate this feature, enter 5000
for the position number.
DUPLICATE DELETE
When the unit is finished searching it will
return to the MENU only if it found and deleted at
least one duplicate number. If it does not find any
duplicate numbers, it will return to edit mode. The
more numbers that are in memory, the longer it takes
to complete this process.