Seaward 300 PrimeTest - Manual (Page 35)

PrimeTest 300
Operating Instructions
- 34 -
9.2 Set Date/Time
The Primetest 300 is equipped with a real-time clock. To
alter
the date or time press Menu (F4), select
Configuration then Set Date/Time and press OK (F4).
Select the values to be changed using the arrow keys,
enter the required value using the keypad and press OK
(F4) to accept.
Note: The time must be entered using a colon to
separate the hours and minutes. A colon is
entered by pressing Shift (F1) followed by the
“3” key.
9.3 Bluetooth Favourites
Refer to section 12 for full details on using Bluetooth.
9.4 Restore Factory Settings
The factory settings can be restored at any time using
this function. The Site, Location and User list will be
restored to the factory settings.
Note: User defined Site, Location and Users lists will
be removed.
9.5 Restore Factory Sequences
The factory test sequences can be restored at any time
using this function.
Note: New or modified test sequences will be
removed if the factory sequences are restored.
9.6 Verify Calibration
After 12 months have elapsed since the last verification
or calibration, the PrimeTest 300 real-time clock will
remind users that verification is required.
Contact an
approved Service Agent to arrange verification.
Note: Verify Calibration is password protected and
can only be accessed by an approved Service
Agent.