Seaward 300 PrimeTest - Manual (Page 34)

PrimeTest 300
Operating Instructions
- 33 -
An example test sequence created to measure
microwave leakage is shown below.
When this test sequence is run using the Automatic Test
Mode described in section 13, the User Test will prompt
for data input as shown below.
The user is now required to enter a measurement and
select a Pass or Fail for this measurement. The
measurement and Pass or Fail information is now stored
as part of the test record.
9.1.6 Print Sequence
This feature allows test sequences to be sent to the
Bluetooth Favourite printer.