How to load the saved parameter, System setup and operation – RGBLink VSP 5360 User Manual

Page 94

6. System Setup and Operation

How to Load the Saved Parameter

VSP 5360 User Manual 94

Push the [Load] button, the button light is on, and enable the

LOAD function.

Some of the number buttons 0-12 in PRE area are on, some flash and

some are off. The buttons on is ready for recall, and flashes means just

recall. OLED shows as follows:

Push the button on to load, for example, button 1, OLED shows as follows:

RECALL USER CONFIG MODE 1
RECALL IS SUCCESSFUL
PROGRAM INPUT:CV2

PUSH THE LEDS ARE ON TO RECALLLED

Button on is ready for recall
Button flashes means just recall