RGBLink VSP 5360 - Manual (Page 46)

4. Menu Orientation
MENU
VSP 5360 User Manual 46
LOGO CAPTURE: Operations are as follows:
Choose the input source.
Freeze image, when capture, the program image should be frozen.
Set the image horizontal position, vertical position, horizontal size and
vertical size.
Save the image to LOGO1 or LOGO2.
Start to capture LOGO.
OUTPUT ADJUST: Settings are as follows:
DVI1 setting as follows:
OUTPUT: User can choose PROGRAM or PREVIEW.
DVI MODE: Can select HDMI agreement or DVI, system default is DVI
output.
BIT DEPTH: Bit depth setting, system default as 8 bit for DVI signal, user
need not set it. And system default as 10 bit, user can also choose 8 bit or
12 bit.
DATE RANGE: DVI1 out range adjustment can choose RGB or YCBCR;
among them the RGB adjusting range is between 0-255, YCBCR adjusting
range from 16 to 235.
DE ADJUST: DE adjust, the sub-menu as following:
DE ON/OFF: Can choose to open or close, when choose open, it can be
adjusted to DE, as follows:
H POS: Horizontal phase setting.
V POS: Vertical phase setting.
H SIZE: Width setting.
V SIZE: Height setting.
H POLARITY: Horizontal polarity setting.
V POLARITY: Vertical polarity setting.
RESET: If image quality distorts by improper operation, it can be recover by
reset.