REMKO SV 261 - Manual (Page 9)

MODE Button
Press the MODE button once or repeatedly to switch to automatic mode.
In this mode, the regulation automatically selects COOL or HEAT mode
depending on the temperature. The temperature is then maintained at
the set value.
The FAN should be set to AUTO.
Press the MODE button to change to another mode. A total of 5 modes
are available:
1. AUTO Automatic mode, automatic selection of cooling or
heating mode
2. COOL Cooling mode, mainly used in summer
3. DRY
Dehumidifying mode, used in summer or winter
4. FAN Circulation mode, no cooling or heating output
5. HEAT Heating mode, mainly used in winter
MODE MODE MODE MODE
Mode AUTO
Press the MODE button once or repeatedly to switch to cooling mode.
Use this mode to cool the room air to the desired target temperature.
Press the TEMP p / q buttons to set the desired room temperature in 1
°C steps. If the room temperature is 1 °C above the desired temperature
and sufficient coolant is available, the indoor unit will start to cool the
room air. f the actual temperature falls approx. 0.5 °C below the set room
temperature, the controller switches the cooling off. Mode COOL
MODE
COOlINg MODE
It is recommended that the
target temperature is set to
max. 6 °C below the outdoor
temperature. The automatic
fan speed and swing functions
should also be used.
NOTE
MODE
TEMP

Cooling
or
Heating
Set temperature
below
room temperature
Set temperature
above
room temperature
9