REMKO SV 261 - Manual (Page 8)

A symbol is shown on the display to indicate that the settings are being transferred.
Button functions
POWER Button
Press the POWER button to activate/deactivate the indoor unit.
The programmed settings and parameters are shown on the display
before the unit switches off.
POWER
TEMP Button
The TEMP button is used to set the desired target temperature
in 1 °C steps. This setting is not supported in FAN
circulation mode.
TEMP

TEMP

RESET Button R Use a small pen or similar to press recessed button R. All the symbols will
appear on the display.
After approx. 5 seconds only the time will flash on the display.
After pressing recessed button C, press and hold the TIME-SET button to
set the time.
Once it has been set, press the C button again to save the time. The
display will stop flashing.
R 5 sec. C
CLOCK Button C
Use a small pen or similar to press recessed button C, the time will flash
on the display. Press and hold the TIME-SET button to, at first slowly,
and then quickly adjust the clock time. Once it has been set, press the C
button again to save the time. The display will stop flashing.
TIME-SET C C
Setting the clock
REMKO SV
8