REMKO SV 261 - Manual (Page 10)

Mode DRY Press the MODE button once or repeatedly to switch to dehumidifying
mode. Use this mode to dehumidify the room in an unregulated fashion.
After pressing the DRY button, select the desired temperature and fin
position. It is not possible to set the fan speed. The fan is switched off at
certain intervals to lower the temperature at the cooling battery. The low
temperature causes the air temperature at the fins to fall below the dew
point. Excess humidity in the air condenses on the cooling battery and
the room is dehumidifed.
MODE
DEHUMIDIfyINg MODE
Mode FAN Press the MODE button once
or repeatedly to switch to
circulation mode. In this mode,
the equipment is used as an
air circulation unit. The room is
neither heated nor cooled.
MODE
CIRCUlATION MODE
This mode allows the heat
trapped under the ceiling to be
circulated to the lower regions
of
the room.
TIP
SWING Button The SWING button is used to provide continual and automatic vertical
adjustment of the fins. This facilitates improved distribution of the cooled
air inside the room. If the SWING button is pressed during the swing
motion, the fins stop in their current position. Pressing the button again
resumes the swing motion.
SWING SWING
SWING SWING SWING SWING
REMKO SV
10