REMKO SV 261 - Manual (Page 6)

Infrared remote control
The infrared remote control can
send the programmed settings
from a distance of 6 m to the
receiver on the indoor unit. Data
will only be received correctly if
the remote control is pointed at
the receiver and no objects are
obstructing the transmission path.
First of all, insert the batteries
supplied with the remote control.
(Two type AAA). Remove the
cover on the battery compartment
and insert the batteries. Take
into account the correct polarity
(see markings).
Operation
The indoor unit is easy to operate
using an infrared remote control.
This is supplied as standard. The
indoor unit beeps to acknowledge
the correct transmission of data.
If it is not possible to program
the indoor unit using the remote
control, it can also be manually
operated.
If the LEDs, flash, a
malfunction has occured in the
indoor unit (see chapter on
trouble-shooting and customer
service).
CAUTION
Immediately replace flat
batteries with a new set,
otherwise there is a risk of
leakage. It is recommended that
the batteries are removed if the
equipment is shut down for
long periods
NOTE
Display
The lit display LEDs indicate the set
fan speed.
LED H red = high
fan speed
LED M yellow = medium
fan speed
LED L green = low
fan speed
Manual operation
The indoor units can be started
manually.
Press the RESET button on the
receiver unit of the cover to
activate automatic mode. The
following settings apply to manual
mode:
Cooling mode: 24 °C,
Fan speed AUTO
Pressing any button on the infrared
remote control interrupts manual
operation.
Receiver on indoor unit
Unit for receiving signals
from the remote control
LED
H
LED
M
LED
L
RESET button
Manual mode
max. 6 m
Max. distance 6 m
REMKO SV
6