REMKO SV 261 - Manual (Page 7)

Buttons on the remote control
Button "POWER"
Press this button to start the
unit.
Button "TEMP"
Press this button to set the
desired temperature in 1 °C
steps within the range 16 °C to
30 °C.
Button "TIME-SET"
Press this button to set the
time.
Button "MODE"
Press this button to select the
operating mode. The indoor unit
has 5 modes:
1. Automatic mode
(COOL/HEAT):
In automatic mode, the
temperature is maintained
at the constant target
temperature.
2. Cooling mode (COOL):
In cooling mode, the warm
room air is cooled to the lower
preset target temperature.
3. Dehumidfiying mode (DRY):
In this mode the room is mainly
dehumidified.
4. Circulation mode (FAN)
In circulation mode only the
room air is circulated. The room
temperature is not controlled.
5. Heating mode (HEAT):
In heating mode the cold room
air is heated to the preset higher
temperature.
Buttons on the remote control
Button "SWING"
This button switches on the
oscillating fins to provide
improved air distribution in the
room. It can also be used to
lock the fins
Button "FAN"
Press this button to set the
required fan speed. 4 levels
are available: Automatic, high,
medium and low fan speed.
Button "TIME-OFF"
This button is used to program
the automatic switch-off
function for the indoor unit.
Button "TIME-ON "
This button is used to program
the automatic switch-on
function for the indoor unit.
Button "C"
Press this button to activate
timer mode.
Button "R"
Press this button to reset the
remote control to its factory
default configuration.
Button "NETWORK"
This button has not been
assigned a function.
Button "SLEEP"
Pressing this button will
automatically increase or
decrease the target temperature
by 1 °C every hour in cooling
and heating mode respectively.
7