REMKO SV 261 - Manual (Page 14)

Cleaning the condensation
pump
The indoor unit includes a built-in
condensation pump for pumping
the condensation to a drain at a
higher level.
The pump is more or less
maintenance free. The
condensation pipes should
be checked for dirt at regular
intervals. Clean them as required.
If an external pump is also used,
observe the maintenance and care
instructions given in the separate
manual.
3 Clean with a vacuum cleaner 4 Cleaning with lukewarm water
1 Open the air inlet guard 2 Remove the filter
Cleaning the cover on the
indoor unit
1. Disconnect the supply voltage
to the equipment.
2. Open and fold down the air
inlet guard on the cover. The
filter is held in place by the flaps
screwed in at the side of the
guard(Fig 1).
3. Clean the guard using a soft,
damp cloth.
4. Switch the supply voltage back
on.
Air filter for indoor unit
Clean the air filter at least every 2
weeks. Reduce this interval if the
air is especially dirty.
Cleaning the filter in the
indoor unit
1. Disconnect the supply voltage
to the equipment.
2. Open and fold down the air
inlet guard on the cover (Fig 1).
The filter is held in place by the
flaps screwed in at the side of
the air inlet guard.
3. Tilt the filter to lift it out (Fig 2).
4. Clean the filter using a normal
vacuum cleaner (Fig 3).
The dirty side should be face
down.
5. Any dirt can be cleaned off
using lukewarm water and mild
cleaning agents (Fig 4).
The dirty side should be face
down.
6. If water is used, let the filter
dry out properly in air before
replacing it in the unit.
7. Carefully insert the filter.
Ensure it locates correctly.
8. Close the cover as described
above but in reverse order.
9. Switch the supply voltage back
on.
10. Switch the unit back on.
REMKO SV
14