REMKO RXT xxx DC - Manual (Page 6)

Operation
Infrared remote control
The infrared remote control sends
the programmed settings over
a distance of up to 6 m to the
receiver of the indoor unit. Data
will only be received correctly if the
remote control is pointed at the
receiver and no objects obstruct
the transmission path.
The batteries (2x AAA) must be
inserted into the remote control in
preparation. To do so, pull off the
flap of the battery compartment
and insert the batteries according
to their polarity (see marks).
The indoor unit is easily operated using the standard infrared remote control. The indoor unit beeps to
acknowledge the correct transmission of data. If it is not possible to program the indoor unit using the remote
control, it can also be operated manually.
Faults are indicated
in code form
(see chapter “Troubleshooting
and customer service”).
Immediately replace flat
batteries with a new set,
otherwise there is a risk of
leakage. It is recommended that
the batteries are removed if the
equipment is shut down for
long periods.
NOTE
Max. 6 m
Maximum distance
Manual mode
The indoor units can be started
manually.
Press the RESET key on the receiver
unit of the cover to activate
automatic mode. In manual mode,
the following settings apply:
Cooling mode: 24 °C,
Fan speed AUTO
Heating mode: 26 °C,
Fan speed AUTO
Pressing any key on the infra-red
remote control
interrupts manual mode.
Display on indoor unit
The LED indicators light up to indicate the settings.
“Operation” LED green = Operation indicator
“Timer” LED yellow = Timer mode
“Pre/Def” LED rot = Defrost mode
“Alarm” LED red = Fault indicator
Display on the indoor unit
Unit for receiving signals
from the remote control
Operation
indicator
Alarm
indicator
Timer
indicator
Defrost
fan
Display on the indoor unit
IR receiver Operation
indicator
Alarm
indicator
Timer
indicator
Defrost
fan
Display
RVD 351-521 DC display
RVD 681-1051 DC display
! CAUTION
REMKO RXT...DC
6