Remko mxd – REMKO MXD 202 User Manual
Page 40
Air filter for indoor unit
Clean the air filter at intervals of no more than two
weeks. Reduce this interval if the air is especially
dirty.
Cleaning the filter
1.
Disconnect the supply voltage to the equip-
ment.
2.
Open and fold down the air inlet guard on the
cover. The filter is held in place by the flaps
screwed in at the side of the guard. (Fig. 45).
3.
Tilt the filter to lift it out (Fig. 45).
4.
Clean the filter using a normal vacuum
cleaner (Fig. 46). To do so, turn the dirty side
upward.
5.
Dirt can also be removed by carefully
cleaning with lukewarm water and mild
cleaning agents. To do so, turn the dirty side
6.
When using water, allow the filter dry out
properly in air before replacing it in the unit.
7.
Carefully insert the filter. Make sure it is
seated correctly.
8.
Close the cover as described above but in
reverse order.
9.
Switch the supply voltage back on.
10.
Switch the unit on again.
Cleaning the condensation pump
The indoor unit includes a built-in condensation
pump, for pumping the condensation to a drain at
a higher level.
The pump is more or less maintenance free. The
condensation pipes should be checked for dirt at
regular intervals. Clean them as required.
If an external pump is also used, observe the
maintenance and care instructions given in the
separate operating manual.
Fig. 45: Pull out the filter
Fig. 46: Cleaning using a vacuum cleaner
Fig. 47: Cleaning with lukewarm water
REMKO MXD
40